Expt #3. Friedel Crafts
Acylation of Naphthalene
Relevant textbook reading - Klein,
Chapter 19.1-19.10
Overview - You will acylate naphthalene with
propionyl chloride/AlCl3 to form propionyl
naphthalene. NMR and GC/MS will be used to determine the
relative yields of the two possible propionyl naphthalene
products.
Procedures
Running the reaction.
- Using the balance located in the dispensing fume
hood, weigh out 11 mmol AlCl3 into a dry
50-mL round bottom flask.
- Add a small stir bar and 10 mL dichloromethane
(DCM).
- Cautiously add 1.0 mL propionyl chloride.
- Attach a reflux condenser, Claisen adapter, and
addition funnel as shown in Fig 7.4a (p 63) in Mohrig.
- Prepare a solution of naphthalene (10 mmol) in 5 mL
DCM and add this to the addition funnel.
- Add the naphthalene solution dropwise over a period
of approx 5 min to the stirring solution.
- Stir for an additional 30 min.
Work-up procedures.
- Slowly add 7.5 mL cold water via the addition funnel
to stop the reaction and quench any left over acyl
chloride.
- Place the flask on an ice bath and slowly add 7.0 mL
concentrated HCl. At this point all of the aluminum
salts should have dissolved. If this is not the case
add another 0.5 mL of HCl.
- Transfer the reaction mixture to a separatory funnel
and drain the lower layer into a small Erlenmeyer
flask. Avoid getting any of the aqueous layer when
carrying out this step.
- Extract the aqueous layer with 5 mL additional DCM
and combine the organic layer with the previous
organic layer.
- Wash the combined organic layers with 5 mL 1% NaHCO3(aq).
Caution, CO2 gas is liberated here so the
separatory funnel will need to be vented early and
often.
- Dry the organic solution over Na2SO4.
- Use the rotary evaporator to remove the DCM solvent
in vacuo.
- Determine the yield.
Characterization
of Product
- Obtain the 1H and 13C NMR
spectrum using CDCl3 as the solvent.
- Dilute 1-2 drops of the NMR sample solution in 5 mL
DCM and submit the solution for GC-MS analysis. (You
will need to process your GC/MS data file using either
WSearch (PC) or OpenChrom (Mac) as was done previously
in Chem 350.)
- Measure the refractive index of the product. (The
instructor or TA will assist you in this.) Mohrig
technique 16.3-16.4.
Assigned Questions
- Use both the proton and C-13 NMR spectra as well as
the GC/MS to determine the relative yields of the two
products (i.e. the product ratio). How well do the
various methods agree with each other?
- Use resonance theory to explain the observed product
ratio. In order to do so properly, you will need to
draw out all resonance structures of the sigma complex
intermediate involved in the formation of both the
1-propionyl and 2-propionyl napthalene products.
|