Expt 1.
Separation of Compounds based on Acidity
Part 2 - Melting Point
Determination and C-13 NMR Spectroscopy
Background
Nuclear magnetic resonance (NMR) is the most important characterization tool
available to organic
chemists. In this lab you will obtain a
C-13 NMR spectrum of each compound
from part 1 in
order to provide evidence that it is the
expected compound.
You will also carry
out mp determinations of the obtained solids from part 1
both as a way to confirm their identities and to assess
their purity.
Pre-Lab
In your prelab include
a prediction of the number of peaks expected in the C-13
NMR spectrum of all three components of the original
mixture.
Experimental
Procedures
Melting
Point Determination
Use a
Mel-Temp apparatus to determine the mp range of each
solid you obtained from part 1. Make sure to follow
all of the precautions necessary for a sharp mp to be
obtained as detailed in Mohrig, Chapter 14. Also be
careful to record your observations during the melting
process and to document the rate of temperature
increase (by recording temperature and time) in your
lab notes.
C-13 NMR
Spectroscopy
There will
only be enough time for you to obtain the spectrum
of one of your three isolated compounds. Each lab
group will be assigned a specific compound and we
will share data between groups so as to be able to
report spectra for all three compounds.
Please note
that you will be expected to obtain NMR spectra many
times in this course and eventually be able to
obtain them unassisted. Therefore, you should take
careful notes on the procedures you use in this lab.
Preparing the NMR Tube.
- NMR tubes and
solvents are very costly so please be very careful
with the tubes and do not waste the solvent. Also,
be very careful when capping and uncapping
your NMR tube. The tubes are very fragile and the
caps are tight so it is easy to break a tube in the
process of capping or uncapping it.
- Use a Pasteur
pipet to add a small amount of your product to your
NMR tube. For C-13 NMR a good amount of compound is
needed to obtain a useful spectrum in the time
available to us, so make sure the height of the
liquid in the tube is at least 1 cm. (For H-NMR we
will use much less.)
- Add the NMR
solvent, CDCl3, to a height
of approx 5 cm in the tube. Cap and then
invert and/or agitate the tube in order to dissolve
the liquid in the solvent (warning - the caps can
leak).
Obtaining the C-13 NMR
Spectrum. The instructor will assist you in
obtaining the NMR. The basic steps are;
Place tube
in spinner and adjust height.
Place tube
with spinner at top of magnet.
Then use the Delta software to...
Lower the
tube and spinner into the magnet.
Check that
tube is spinning and the correct solvent is selected.
Lock and
shim the sample.
Set up the
desired experiment (in this case C-13) with a file
name of your choosing.
Submit the
experiment.
Eject the
tube from the magnet.
Disposal and Clean Up.
- NMR sample
solutions should be drained into the waste solvent
container. Be very careful when removing the
plastic cap as it is easy to break the top of the
tube when doing so. Rinse the tube several
times with acetone into the waste solvent container.
Store the tube uncapped so the acetone will fully
evaporate by the time of its next use.
Product
Submission - Submit your solid "products" in
fully labeled (name, course, compound name or
structure) glass vials.
|